Foxconn RC4107MA-8KRS2 User Manual Page 25

  • Download
  • Add to my manuals
  • Print
  • Page
    / 89
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 24
Chapter 2 Installation Instructions
18
IrDA Connector: IR
This connector supports wireless transmitting and re-
ceiving device. Before using this function, configure the
settings of IR Mode from the Integrated Peripherals
section of the CMOS Setup.
IR
+5V
GND
IRRX
IRTX
Empty
1
Serial ATA Connectors : SATA_1, SATA_2, SATA_3, SATA_4
SATA _1/SATA _2/
SATA _3/SATA _4
The Serial ATA connector is used to connect the Serial
ATA device to the motherboard. These connectors sup-
port the thin Serial ATA cables for primary internal stor-
age devices. The current Serial ATA interface allows up
to 300MB/s data transfer rate.
GND
GND
GND
TX+
TX-
RX+
RX-
1
Front Audio Connector: F_AUDIO
For -6 models (optional)
AUD_OUT-L
NA
MIC_IN
MIC_PWR
F_AUDIO
MIC_GND
+5VA
AUD_OUT-R
AUD_RET-R
Empty
AUD_RET-L
1
The audio connector provides two kinds of audio output choices: the Front Audio,
the Rear Audio. Their priority is sequenced from high to low (Front Audio to Rear
Audio). If headphones are plugged into the front panel of the chassis (using the
Front Audio), then the Line-out (Rear Audio)
on the rear panel will not work. If you do
not want to use the Front Audio, pin 5 and
6, pin9 and 10 must be SHORT, and then
the signal will be sent to the rear audio
port.
The audio connector provides two kinds
of audio output choices: the Front Audio,
the Rear Audio. Front Audio supports re-
tasking function. Their priority is the same.
For -8 models (optional)
SENSE_SEND
PORT1_L
PORT1_R
PORT2_L
F_AUDIO
AUD_GND
PRESENCEJ
PORT2_R SENSE1_RETURN
Empty
SENSE2_RETURN
1
PDF 文件使用 "pdfFactory" 试用版本创建 www.fineprint.com.cn
Page view 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 88 89

Comments to this Manuals

No comments