Foxconn A85GM User Manual download pdf (Page 33)

► Smart Power LED

Smart Power LED is a feature built on your motherboard to indicate different states during

Power On System Test (POST). The LED is located at the front panel, and it displays POST

state by different long-short blinking intervals. You can always leave this state enabled.

System Status Power LED Status Stop Blinking Condition

Normal Always On Always On

No Memory Continue blinking On (1sec.), Off (1sec.) Reboot & Memory OK

No VGA Card detec Continue blinking On (2sec.), Off (2sec.) Reboot & Display OK

Post Error Message

Quick blinking twice (1/3sec. On, 1/3sec. Off),

one long On (1sec.), continuously.

Enter Setup or Skip

No CPU Fan Continue blinking On (1/2sec.), Off (1/2sec.) Reboot & Fan OK

► Smart Boot Menu

When PC starts, it will ask you to press [Del] key to enter setup or press [Esc] key to enter

smart boot menu. If [Disabled] is selected, then pressing [Esc] has no function.

► Current CPU Speed

This item displays the current CPU speed.

► Current FSB Multiplier

This item displays the current FSB Ratio.

► Current DRAM Speed

This item displays the current DRAM speed, in dual channels.

Fox Intelligent Stepping

CPU Clock [200] Help Item

Memory Speed Mode [Auto]

GFX Engine Clock Override [Disabled]

PCI Express Clock [100]

CPU Multiplier Adjust [Auto]

Spread Spectrum [Enabled]

CPU-NB HT Link Speed [Auto]

NCHT Incoming Link Width [Auto]

NCHT Outgoing Link Width [Auto]

↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit

F1:General Help F9:Optimized Defaults

200

► CPU Clock

This option is used to adjust the CPU clock.

► Memory Speed Mode

This item is used to enable/disable provision of DRAM timing by SPD device. The SerialPres-

ence Detect (SPD) device is a small EEPROM chip, mounted on a DDR2 memorymodule. It

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 103 104

No comments

Foxconn A85GM User Manual Page 33