Foxconn K8M890M2MA-KRS2H User Manual download pdf (Page 17)

Chapter 2 Installation Instructions

Other Connectors

This motherboard includes connectors for FDD devices, IDE devices, Serial ATA

devices, USB devices, IR module, and others.

FDD Connector: FLOPPY

This motherboard includes a standard FDD connector, supporting 360K, 720K,

1.2M, 1.44M, and 2.88M FDDs.

HDD Connectors: PIDE & SIDE

This connectors supports the provided Ultra DMA 133/100/66/33 IDE hard

disk ribbon cable. Connect the cable’s blue connector to the primary

(recommended) or secondary IDE connector, then connect the gray connector

to the Ultra DMA 133/100/66/33 slave device (hard disk drive) and the black

connector to the Ultra DMA 133/100/66 master device. If you install two hard

disks, you must configure the second drive as a slave device by setting its jumper

accordingly. Refer to the hard disk documentation for the jumper settings.

Attention:

Ribbon cables are directional, therefore, make sure to

always connect with the cable on the same side as pin 1 of the

PIDE/SIDE or FDD connector on the motherboard.

PDF 文件使用 "pdfFactory" 试用版本创建 www.fineprint.com.cn

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 68 69

No comments

Foxconn K8M890M2MA-KRS2H User Manual Page 17