Foxconn G9657MA-8EKRS2H User Manual download pdf (Page 22)

Chapter 2 Installation Instructions

Serial ATA II Connectors: SATA_1, SATA_2,

SATA_3, SATA_4

The Serial ATA II connector is used to connect

the Serial ATA II device to the motherboard. These

connectors support the thin Serial ATA II cables

for primary storage devices. The current Serial

ATA II interface allows up to 300MB/s data trans-

fer rate.

CPU_FAN SYS_FAN1 SYS_FAN2

SATA_1/2/3/4

GND

GND GND

RX+

RX-TX-

TX+

Chassis Intruder Connector: INTR (optional)

The connector connects to the chassis secu-

rity switch on the case. The system can detect

the chassis intrusion through the status of this

connector. If the connector has been closed

once, the system will send a message. To uti-

lize this function, set “Case Open Warning” to

“Enabled” in the “PC Health Status” section of

the CMOS Setup. Save and exit, then boot the

operating system once to make sure this func-

tion takes effect.

INTR

1 INTRUDERJ 2 GND

The fan speed can be detected and viewed in

“PC Health Status” section of the CMOS Setup.

These fans will be automatically turned off after

the system enters S3, S4 and S5 mode.

Fan Connectors: CPU_FAN, SYS_FAN1,

SYS_FAN2

SENSE

GROUND

POWERCONTROL

1394 Connector: F_1394

The 1394 expansion cable can be connected

to either the front (provided that the front panel

of your chassis is equipped with the appropri-

ate interface) or real panel of the chassis.

GND

+12V

TPB -

GND

TPA -

+12V

TPB +

GND

TPA +

Empty

F_1394

910

PDF 文件使用 "pdfFactory" 试用版本创建 www.fineprint.com.cn

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 68 69

Comments to this Manuals

No comments

Foxconn G9657MA-8EKRS2H User Manual Page 22

Comments to this Manuals

Related products and manuals for Motherboard Foxconn G9657MA-8EKRS2H